[missing-sync-palmos-talk] Sync with StickyBrain

[Mac Mike]

Hi Rob,

If I understood you correctly, I think this should be a fairly easy one.
You can set up different "Profiles" that will enable you to configure &
enable the conduits and save that specific setup.

The "Profiles" can be found near the upper right hand side of the main
Missing Sync window.  It has some basic pre-configured settings like,
"Backup", "Install", and "All Conduits".  However, you can save any
configuration you wish and use it for a later time.

The "Profile" selected will only affect the conduits settings and
selections.  It will not change the "Current Handheld" setting.  I just
tested this.

Since I don't sync multiple handhelds, I don't know if the "Current
Handheld" is automatically selected when the device is docked.  I'm guessing
it will not be auto selected since this could cause issues if both PDA's
where docked at the same time.

So, the simple solution is to select the "Current Handheld" that you wish to
sync and select the "Profile" that matches that handheld device (you must
create this profile yourself) - then sync.

-Mike

PS - I use Sticky Brain as well, and I do not see any setting for the
conduit beyond the typical sync, force one way, & do nothing settings.


On 8/16/05 12:55 AM, "Rob Gendreau" <rob.gendreau at gmail.com> wrote:

> I¹m using Missing Sync to sync with StickyBrain, which has a conduit
> of its own. But Stickybrain has no provision for distinguishing
> between my two handhelds (Adobe Palm Reader can do this, as an
> example). I can sync to one or the other, but not without deleting
> notes and then turning on and off the conduit. Is there any easier
> way to accomplish syncing different notes to different PDAs?
> Rob